Pentax K10D - Page 157

155
4
Function Reference
• Turn the front e-dial while pressing the m button to change the EV
Compensation value. (p.161)
• Set the shutter speed and aperture values in increments of 1/2 EV or 1/3 EV.
Set in [EV Steps] in the [A Custom Setting] menu. (p.162)
• Settings other than [AUTO] are not available in [Sensitivity] in the Fn menu.
• Set the aperture to the s position while
holding down the auto-lock button when
using a lens with an aperture ring.
Exposure Warning
If the subject is too bright or too dark,
the shutter speed and aperture value
will blink in the viewfinder and on the
LCD panel.Change the shutter speed and aperture value. When the
indication stops blinking, you can take the picture with proper
exposure.
Use an ND (Neutral Density) filter if the subject is too bright.
Use a flash if it is too dark.