Pentax Optio WG-2GPS - Page 119

117
3
Taking Pictures
1 Use the four-way controller (2345) to select (Interval
Movie) from the Capture Mode Palette.
2 Press the 4 button.
The current Interval Movie setting appears for approximately one minute. To
take pictures with the current settings, go to step 10.
3 Press the 4 button while the settings are displayed.
The Interval Movie setting screen appears. [Interval] is marked with the frame.
4 Set the interval.
1 Press the four-way controller (5).
A pull-down menu appears.
2 Use the four-way controller (23)
to set the interval, then press the
4 button.
The frame returns to [Interval].
5 Press the four-way controller (3).
The frame moves to [Total Time].
6 Set the total time.
1 Press the four-way controller (5).
2 Use the four-way controller (23) to set the hours, then press
the four-way controller (5).
3 Use the four-way controller (23) to set the minutes, then press
the four-way controller (5).
The frame returns to [Total Time].
7 Press the four-way controller (3).
The frame moves to [Start Delay].
8 Set the start delay.
1 Press the four-way controller (5).
2 Use the four-way controller (23) to set the hours, then press
the four-way controller (5).
3 Use the four-way controller (23) to set the minutes, then press
the four-way controller (5).
The frame returns to [Start Delay].
9 Press the 3 button.
The Interval movie setting is saved and the camera returns to capture mode.
MENU
Total Time
1
00
hr.
0
min.
10
Interval Shot
Interval
Start Delay
min.
hr.
0
min.
0