Pentax Optio WG-2GPS - Connecting the Camera to an HDMI Terminal

142
4
Playing Back and Deleting Images
Use a commercially available HDMI cable to connect the camera to a device with
an HDMI terminal.
1 Turn the AV device and camera off.
2 Open the terminal cover.
Move the terminal cover lock lever in the direction shown by 1, slide the cover
in the direction shown by 2 and open the cover in the direction shown by 3.
3 Connect the HDMI cable to the HDMI terminal.
4 Connect the other end of the HDMI cable to the HDMI terminal
on the AV device.
5 Turn the AV device and camera on.
The camera information is displayed on the screen of the connected AV device.
Connecting the Camera to an HDMI Terminal
• The camera has a Type D (Micro) HDMI terminal. Use a commercially
available HDMI cable that matches your AV device.
• If you play back movies by connecting the camera to an AV device with a
commercially available HDMI cable, set the output format to “Selecting the
HDMI Output Format” (p.188).
Close the terminal cover securely when not using the terminal.
<How to close the terminal cover>
Close the cover in the opposite direction indicated by 3. While lightly
pressing on the terminal cover, slide it away from 2 until it clicks.
HDMI
terminal