83
3
Taking Pictures
You can use the remote control (optional) to take pictures while you are away
from the camera.
1
Press the four-way controller (2) in A mode.
The [Drive Mode] screen appears.
2
Use the four-way controller (45) to select i and press the
four-way controller (3).
3
Use the four-way controller (45)
to select i or h and press the
4 button.
The self-timer lamp begins to blink slowly
and the camera is ready to take a picture
with the remote control.
When the camera detects a person’s face,
the Face Detection function is activated
and the face detection frame appears (p.69).
•With j, you can continue shooting until the memory capacity of the SD
Memory Card or built-in memory is full.
• The interval of j varies according to the [Recorded Pixels] and [Quality
Level] settings.
• The focus, exposure and white balance are locked with the first shot.
• When the Face Detection function is activated (p.69), it works only when
taking the first shot.
• The Blink Detection function works only for the last shot.
• The number of recorded pixels is fixed at f/ in c mode. When the
shooting mode is set to (Report), the number of recorded pixels is set
to V.
Taking Pictures Using the Remote Control Unit
(Optional)
i
The shutter will be released after about three seconds when the shutter release
button on the remote control unit is pressed.
h
The shutter will be released immediately when the shutter release button on
the remote control unit is pressed.
MENU
To Next Page
Loading...
Need help?
General
