193
7
Settings
You can choose the start-up screen displayed when the camera is turned on.
You can choose any of the following images as the start-up screen:
• The Guide Display Start-up Screen showing a guide for the shooting modes
and buttons
• One of the 3 pre-installed screens
• One of your own images (compatible images only)
1
Use the four-way controller (2345) to select ^ (Start-up
Screen) from the Playback Mode Palette.
2
Press the 4 button.
The image selection screen appears.
3
Use the four-way controller (45)
to choose the image for the start-
up screen.
Only images available for the start-up
screen are displayed. You can also choose
one of the 3 pre-installed screens or the
Guide Display Start-up Screen already
stored in the camera.
4
Press the 4 button.
The setting is saved.
Changing the Start-up Screen
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card or built-in memory is
formatted. However the image is deleted if you change the start-up screen
after deleting the recorded image or formatting the memory.
• The start-up screen is not displayed when set to [Off].
• The start-up screen is not displayed when you turn the camera on in
playback mode.
• Movies or images taken at F (Digital Panorama) mode cannot be used
for the start-up screen.
Cancel
To Next Page
Loading...
Need help?
General
