Pentax Optio WG-2GPS - Page 82

80
3
Taking Pictures
4 Set the interval.
1 Press the four-way controller (5).
2 Use the four-way controller (23)
to set the minutes, then press the
four-way controller (5).
3 Use the four-way controller (23)
to set the seconds, then press the
four-way controller (5).
The frame returns to [Interval].
5 Press the four-way controller (3).
The frame moves to [Number of Shots].
6 Set the number of shots.
1 Press the four-way controller (5).
2 Use the four-way controller (23) to set [Number of Shots],
then press the four-way controller (5).
The frame returns to [Number of Shots].
7 Press the four-way controller (3).
The frame moves to [Start Delay].
8 Set the start delay.
1 Press the four-way controller (5).
2 Use the four-way controller (23) to set the hours, then press
the four-way controller (5).
3 Use the four-way controller (23) to set the minutes, then press
the four-way controller (5).
The frame returns to [Start Delay].
9 Press the 3 button.
The [Interval Shot] settings are saved and the camera returns to capture mode.
10 Press the shutter release button halfway.
The focus frame on the display turns green if the subject is in focus.
11 Press the shutter release button fully.
Interval shooting starts.
The LCD turns off between shots (during standby). Press the power switch during
standby to display the remaining number of shots and interval on the monitor.
The [Stop interval shooting?] message is displayed when the power switch and
then the 3 button are pressed during standby. Pressing the 4 button
cancels interval shooting.
MENU
Interval
Number of Shots
Start Delay
min.
0
hr.
0
min.
0
2
sec.
10
Interval Shot