31
CB 240 Climbing Formwork
Instructions for Assembly and Use – Standard Configuration
B1 Work on the Construction Site
Anchoring
Check if the cone fits correctly and is
clean.
Assembly of Scaffold Mounting Ring
M24
1. Turn over wire nails with a hammer.
2. Remove the Anchor Positioning Stud
M24 (5.11) from the cone with an Al-
len Key SW 14. (Fig. B1.16)
3. Place the Scaffold Mounting Ring M24
(5.6) on the cone cup of the Screw-On
or Climbing Cone (5.1/5.3) and secure
using bolt M24 x 120 ISO 4014-10.9
(5.7). (Fig. B1.17)
4. Firmly tighten bolt by hand using socket
wrench SW 36. (Fig. B1.18)
Fig. B1.16
Fig. B1.17
Fig. B1.18
5.11
5.6
5.1
5.7
5.3
AuV CB 240 EX.indb 31 29.06.16 09:44
To Next Page
Loading...
