Peri CB 240 - Formwork Alignment

51
4.5
4.8
4.6
4.3
4.7
10
4.3
4.8
4.4
4.8
4.6
CB 240 Climbing Formwork
Instructions for Assembly and Use – Standard Configuration
B3 Formwork Utilisation
Formwork Alignment
Height Adjustment with the Connec-
tor TRIO-CB for TRIO
1. On the top Connector, alter the adju-
sting spindle (4.8) for necessary clea-
rance.
2. On the lower Connector, lower adju-
sting spindle (4.8) onto the locking pin
(4.6).
3. Turn adjusting spindle using the ratchet
lever SW 19 and bring formwork into
position. Depending on the rotational
direction, the formwork moves up-
wards or downwards. (Fig. B3.04)
Is there enough clearance for adjust-
ment on the top connector?
Height Adjustment with the VARIO
GT 24 Height Adjusting Unit
Apply ratchet lever SW 19 to adjusting
spindle (4.8) of the Height Adjusting Unit
CB (4.3) on the Strongback.
Depending on the rotational direction,
the formwork moves upwards or down-
wards. (Fig. B3.05)
If the formwork does not move, loose-
ning of the Waler Fixation (4.4) will make
the adjustment easier.
Fig. B3.05
Fig. B3.04
AuV CB 240 EX.indb 51 29.06.16 09:45