Permobil ICS - Changing Seat Width Setting on K450

56
56
Changing the Seat Width Setting on K450:
1. Enter the Seat Width Selection mode:
a) With the wheelchair off, press and hold Buttons 3, 4 & 6 on the ICS Switchbox.
b) While holding these buttons, turn on the wheelchair with the Joystick (or Input Device).
c) When all LEDs on the ICS Switchbox turn green, continue to hold the buttons.
d) After approximately five seconds, the switchbox will emit a rapid beep and the LEDs will
change. Release Buttons 3, 4 & 6.
• LED #7 will flash GREEN* and LED #8 will flash RED* to denote Seat Width Selection mode.
2.
Select the desired Seat Width Setting:
a) Once in the Seat Width Selection mode, the current setting will be displayed.
b) Select the desired value using Button 1 and 5 on the switchbox.
• Button 1 will increase the setting and Button 5 will decrease the setting.
3.
Save the desired setting:
a) When the desired setting is displayed, press and hold Button 8 for two seconds to save.
b) Turn off the wheelchair to exit the Seat Width Selection mode.
c) Turn the wheelchair on and confirm the seat operates as desired. If not, repeat the process.
* The following applies for config. files prior to October 15, 2010. LED 7 flashes red and LED 8 flashes green to
indicate seat width selection mode.
Programming K450 - Specific Attributes