70
Programming APE-actuator Recalibration Mode
APE-actuator Recalibration Mode
If the Linak LA28 actuator, item 324195, used in the Corpus APE and Corpus VS is replaced or detects
a position fault the wheelchair will enter a recalibration mode where the Linak actuator moves into cali-
bration position in an effort to recalibrate the sensor. In this mode any button on the switchbox will move
the Linak actuator down, recline and legrest can also be adjusted during this phase to ensure that that
no mechanical interference will occur. When the Linak actuator has moved to mechanical end position it
is calibrated and triggers a restart request. After restart the seat functions is working normally again.
During recalibration mode LED #1 on the ICS switchbox is flashing red/yellow and the buttons
have the following functions
Any active button moves Linak actuator down
Button 5 will also lower the Linix actuator, (front actuator of APE)
Button 3 & 7 will also operate Backrest
Button 5 & 8 will also operate Legrest
To Next Page
Loading...