Permobil ICS - Setting Corpus Seat Depth

37
Programming Corpus 3G/HD/APE/VS - Specific Attributes
Setting of Corpus 3G/HD/APE/VS Seat Depth
The correct seat depth has to be set in the ICS to make
the leg rest stop in the right position and not collide
with the chassis and to reduce the speed on chassis
with front casters when the foot plates are in the vicinity
of the castors. On delivery of the wheelchair, this is
already done but when the seat depth changes or if
the control system is reprogrammed / updated setting
of the seat depth could be needed after delivery. It is
performed as follows:
1. To enter the Seat Depth Selection mode:
a) With the wheelchair off, press and hold Buttons 3, 4 & 6 on the ICS Switchbox
b) While holding these buttons, turn on the wheelchair
c) When all LEDs on the ICS Switchbox turn green, release the buttons.
LED #7 will flash GREEN and LED #8 will flash RED to denote Seat Depth Selection mode
2. Select the desired Seat Depth Setting:
a) Once Seat Depth selection mode, the current setting will be displayed
b) Select the desired value using Button 1 and 5 on the switchbox
Button 1 will increase and button 5 will decrease the setting
3. Save the desired setting:
a) When desired setting is displayed, press and hold Button 8 for two seconds to save.
b) Cycle power on the wheelchair and verify that the seat operates as desired. If not repeat the
process.
Seat Depth Indication at setting of Seat Depth
470mm (18”) or shorter
1
2
3
4
5
6
8
7
1. Solid green
7. Flashing green
8. Flashing red
495mm (19”)
1
2
3
4
5
6
8
7
1-2. Solid green
7. Flashing green
8. Flashing red
520mm (20”)
1
2
3
4
5
6
8
7
1-3. Solid green
7. Flashing green
8. Flashing red
545mm (21”)
1
2
3
4
5
6
8
7
1-4. Solid green
7. Flashing green
8. Flashing red
570mm (22”)
1
2
3
4
5
6
8
7
1-5. Solid green
7. Flashing green
8. Flashing red
595mm (23”)
1
2
3
4
5
6
8
7
1-6. Solid green
7. Flashing green
8. Flashing red
620mm (24”)
1
2
3
4
5
6
8
7
1. Solid red
7. Flashing green
8. Flashing red