51
51
Setting Legrest Type
The VS Seat has two styles of legrest available. In order for the wheelchair to operate correctly, the legrest
type must be stored in the Intelligent Control System.
By default, the system is set with the “Stand NO Drive” legrest option.
To change the Legrest Type:
To enter the Legrest Selection mode, the system needs to be started up with a combination of pressed
buttons: Press and hold Button 1, 2 and 7 on the ICS Switchbox, while holding these buttons, turn on the
wheelchair with the Power Button on the Joystick (or Input Device).
Once all LEDs on the ICS Switchbox turn green, release Buttons 1, 2 and 7.
• LED #7 flashes RED and LED #8 flashes GREEN to signify Legrest Selection mode.
The Legrest type is represented with LEDs 1, 2 on the ICS Switchbox. Ignore LEDs 3-6 when adjusting
this setting.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Stand
NO
Drive
Stand
and
Drive
Press Button 1 or Button 5 to change the Legrest type.
After the appropriate Legrest type is displayed with the LEDs, press and hold Button 8 for two seconds to
save the setting. Turn the wheelchair off and back on to continue normal usage.
Solid Green
Solid Red
Programming VS - Specific Attributes
To Next Page
Loading...