Index
Contents ...............................................................................Chapter - Page
13.05.02 Knife stroke............................................................................................................ 13 - 30
13.05.03 Knife motion........................................................................................................... 13 - 31
13.05.04 Knife position ......................................................................................................... 13 - 32
13.06 Adjusting the edge trimmer -725/04 for the 1474E1 ......................................... 13 - 33
13.06.01 Replacing the knife ................................................................................................ 13 - 33
13.06.02 Knife height............................................................................................................ 13 - 34
13.06.03 Knife stroke............................................................................................................ 13 - 35
13.06.04 Knife motion........................................................................................................... 13 - 36
13.06.05 Knife position ......................................................................................................... 13 - 37
13.07 Adjusting the thread trimmer -900/53................................................................ 13 - 38
13.07.01 Removing the scissor ............................................................................................ 13 - 38
13.07.02 Control cam with respect to bobbin opener and tripping lever .............................. 13 - 39
13.07.03 Radial position of the tripping lever........................................................................ 13 - 40
13.07.04 Engaging solenoid.................................................................................................. 13 - 41
13.07.05 Scissor drive lever.................................................................................................. 13 - 42
13.07.06 Adjusting the control cam with the adjustment gauge in relation to the
bobbin opener and the scissor ............................................................................... 13 - 43
13.07.07 Radial position of the control cam in relation to the bobbin opener ....................... 13 - 44
13.07.08 Tripping lever of scissor in relation to the control cam of the scissor .................... 13 - 45
13.07.09 Control cam in relation to the scissor .................................................................... 13 - 46
13.07.10 Scissor return lever................................................................................................ 13 - 47
13.07.11 Scissor return control............................................................................................. 13 - 48
13.07.12 Fitting the scissor................................................................................................... 13 - 49
13.07.13 Eccentric sleeve..................................................................................................... 13 - 50
13.07.14 Scissor driving rod.................................................................................................. 13 - 51
13.07.15 Scissor function test .............................................................................................. 13 - 52
13.08 Tension release (only on machines with thread tension control -906/10)...... 13 - 54
13.09 Parameter settings............................................................................................... 13 - 55
13.09.01 Adjusting positions................................................................................................. 13 - 55
13.09.02 Setting the counter ................................................................................................ 13 - 56
13.09.03 Setting the speed................................................................................................... 13 - 56
To Next Page
Loading...
Need help?
General
