• The MEMORY button does not func-
tion if REPEAT PLAY is ON.Details
are on page 41.
• To erase a real-time counter memo-
ry,press the MEMORY button until
the M disappears from the screen.
• You may only set the real-time
counter to zero at one location at a
time.If you set the real-time counter
to zero at a second location,the
previous real-time counter to zero
setting will be erased.
• If you remove the tape,the counter
will reset to zero at the point at
which you last stopped playback
whenever you reinsert the tape.
Helpful Hints
STOP 1:08PM
TV STEREO CH10
SLP 1 :23 :45 HIFI
Follow the steps below to reset the real-time counter to zero at a
tape location you want to refer to later.
● Before you begin, place the DVD/VCR in VCR mode.
Press the OUTPUT SELECT button so that the green VCR OUT-
PUT light appears on the front of the DVD/VCR.
1
Press the VCR button, then play, fast forward, or rewind a
tape to the location that you would like to refer to later.
Press the Stop C button to stop the tape.
2
Press the DISPLAY/STATUS/EXIT button to see the sta-
tus display.
3
While the status display is on the screen,press the
CLEAR button to reset the real-time counter to zero.
STOP 1:08 PM
TV STEREO CH10
SLP 0 :00 :00 HIFI
4
While the real-time counter is on the screen, press the
MEMORY button so that M appears beside the counter.
STOP 1:08 PM
TV STEREO CH10
SLP M 0 :00 :00 HIFI
5
To go to a tape location where the real-time counter was
reset to zero,press the Rewind h button or the Fast
Forward g button when playback is stopped.
When the tape reaches the point at which the counter was set to
zero,the tape will stop.Press the Play B button to watch the
tape.
42 Real-Time Counter Memory
2
3
4
5
1
VCR
DV910(H9100).QX33 01.8.9 10:26 AM Page 42
To Next Page
Loading...
