Automatic Operation Features
43
The following tape features are available in VCR mode. Press VCR so
the VCR light is on, if necessary.
Automatic Playback
When you put a tape in the DVD/VCR, the power will come on. If
the tape’s record tab is missing, playback will begin.
If a timer recording is set and is flashing in the display panel,
the power will not come on automatically when you insert a tape
with the record tab intact.
If a timer recording is set and is flashing in the display panel,
the DVD/VCR will eject the tape if the record tab is missing.
Automatic Rewind, Eject
When a tape is played, fast forwarded, or recorded to its end, the
tape will rewind to the beginning, stop, and eject itself.
This feature does not operate if AUTO REPEAT is ON. Details are
on page 39.
Ta pe Eject
A tape can be ejected with the DVD/VCR power on or off (but
the DVD/VCR must be plugged in).
If a timer recording is set and appears on the display panel,
pressing STOP/EJECT C A (VCR) will turn on the DVD/VCR
and/or cancel the timer recording.The will turn off. Press
STOP/EJECT C A (VCR) again to remove the tape. Remember to
insert a tape and press TIMER SET to reset the timer recording.
Automatic Tracking Adjustment
The VCR adjusts tracking automatically to give you the best possible
picture quality.With some recordings, however, you may get a better
picture using manual tracking.
Manual Tracking
To manually adjust the tracking during normal playback and slow
motion playback of a videotape, press SKIP
∑/CH o or SKIP w/
CH p on the remote.
Tracking will return to Automatic Tracking when you press STOP
C or insert a tape.
You can also press SKIPSKIP ∑/CH o or SKIP w/ CH p to
remove vertical jitter in a Still picture.
Before
Tracking
Adjustment
After
Tracking
Adjustment
To Next Page
Loading...
