Philips HeartStart MRx - Changing the EtCO2 Alarm Limits; Enabling;Disabling the EtCO2 Alarms; Changing the AwRR Alarm Limits

EtCO
2
and AwRR Alarms 10 Monitoring Carbon Dioxide
115
Changing the EtCO
2
Alarm Limits
To change the EtCO
2
alarm limits:
1 Press the Menu Select button.
2 Using the Navigation buttons, select the Measurements/Alarms menu and press the Menu Select
button.
3 Select EtCO
2
and press the Menu Select button.
4 Select EtCO
2
Limits and press the Menu Select button.
5 Using the Navigation buttons, increase or decrease the high limit value and press the Menu Select
button.
6 Set the new low limit value and press the Menu Select button.
Enabling/Disabling the EtCO
2
Alarms
To enable or disable the EtCO
2
alarms:
1 Press the Menu Select button.
2 Using the Navigation buttons, select the Measurements/Alarms menu and press the Menu Select
button.
3 Select EtCO
2
and press the Menu Select button.
4 Select Alarms On/Off and press the Menu Select button.
Changing the AwRR Alarm Limits
To change the AwRR alarm limits:
1 Press the Menu Select button.
2 Using the Navigation buttons, select the Measurements/Alarms menu and press the Menu Select
button.
3 Select AwRR and press the Menu Select button.
4 Select AwRR Limits and press the Menu Select button.
5 Using the Navigation Buttons, increase or decrease the high limit value and press the Menu Select
button.
6 Set the new low limit value and press the Menu Select button.