Setting Up for Bluetooth Transmission 14 12-Lead ECG Transmission
147
Setting Up for Bluetooth Transmission
12-Lead ECG Transmission using Bluetooth
®
requires the configuration and set up of wireless devices
that will send the 12-Lead Report to the hub.
NOTE For further information concerning the setup and configuration of transmission devices and the
HeartStart MRx, refer to the 12-Lead Transmission Implementation Guide. For further information
concerning the 12-Lead Transfer Station, refer to the 12-Lead Transfer Station Instructions for Use.
Adding a Bluetooth Device
Up to 20 Bluetooth devices may be configured for use. Adding a twenty-first device replaces the device
used least recently.
NOTE Bluetooth devices may not be added or modified during 12-Lead transmission. Conversely, 12-Lead
transmission is not allowed during Bluetooth device configuration.
To add a Bluetooth device to the list of Transmission Devices:
1 Once in 12-Lead mode, press the Menu Select button.
2 Using the Navigation buttons, select Bluetooth Devices and press the Menu Select button. A list of
discovered Bluetooth devices is displayed.
3 Select Add Device and press the Menu Select button. The message Searching for Bluetooth Devices
is displayed.
4 From the Add Device menu, select the desired device and press the Menu Select button.
The selected device must now go through the “Pairing” process described below.
NOTE All Bluetooth devices within the specified range are discovered by the HeartStart MRx and are
displayed on the Add Device menu, even if you have already paired with the device.
Pairing a Bluetooth Device with the HeartStart MRx
Once a Bluetooth device is selected from the Add Devices menu, a passkey sequence must be
performed in order to communicate or “pair” the wireless device with the HeartStart MRx. The
passkey is user-defined character sequence, such as 000, or 1234, etc.
Some Bluetooth devices only allow pairing for 30 seconds, so be ready to enter the passkey.
1 Use the Navigation buttons to enter the passkey on the MRx and select Done.
The Bluetooth device prompts you for a passkey.
2 Enter the same passkey on your Bluetooth device. See the documentation that came with your
Bluetooth device for instructions.
3 Select the designated profile from the Phone/Modem Profiles menu.
NOTE The profile contains specific information about the Bluetooth device that enables it to communicate
with the 12-Lead Transfer Station. Your administrator sets up the profiles and can tell you which one
to choose.
To Next Page
Loading...
