Display Views 2 Getting Acquainted
19
Menus
Menus with controls and options specific to each function of the HeartStart MRx are easily accessible
using the Menu Select and Navigation buttons located on the front panel. Menus are used to adjust
volume, select waveforms for display, select waves for printed strips, set alarms, schedule
measurements, enter patient information, perform the Operational Check, generate reports, and a
variety of other tasks. Menus and submenus are organized to allow you to conveniently make selections
and enter information.
To display a menu, press the Menu Select button. Then use the up or down Navigation
buttons to scroll through the available choices until the desired selection is highlighted. To activate the
selection, press the Menu Select button. Select Exit to close the menu without activating a selection.
Figure 9 Sample Menu
Message Windows
Periodically, message windows appear on the display to provide additional status information, alert you
to an error or a potential problem, or direct you to take action. Remain alert to these messages. If a
response is required, use the Navigation and Menu buttons to highlight and select the appropriate
answer.
Figure 10 Sample Message Window
HR/Arrhythmia
Relearn Rhythm
Alarms Off
HR Limits
VTACH Limits
Exit
Connect Pads Cable
To Next Page
Loading...
