Philips HeartStart MRx - Setting Up for RS 232 Transmission

14 12-Lead ECG Transmission Setting Up for RS 232 Transmission
150
Setting Up for RS 232 Transmission
12-Lead ECG Transmission using RS 232 requires a serial cable connected to the RS 232 Serial Port
located on the back panel of the HeartStart MRx. See Figure 68. The cell phone is connected to the
serial cable as shown in Figure 69.
NOTE For further information concerning the setup and configuration of transmission devices and the
HeartStart MRx, refer to the 12-Lead Transmission Implementation Guide. For further information
concerning the 12-Lead Transfer Station, refer to the 12-Lead Transfer Station Instructions for Use.
Figure 68 RS 232 Serial Port Connection