Phoenix Contact FL SWITCH 2005 - Figure 5-11 Firmware Update Via HTTP Pop-Up; Figure 5-12 Firmware Update Via TFTP Pop-Up

FL SWITCH 2000
34
PHOENIX CONTACT 107065_en_01
Pop-up: Update Firmware
Update via HTTP: select “HTTP” as the method. Clicking on “Browse” allows you to select
the desired file on your PC. Clicking on “Apply” starts the update.
Figure 5-11 “Firmware Update via HTTP” pop-up
Update via TFTP: select “TFTP” as the method.
Figure 5-12 “Firmware Update via TFTP” pop-up
– TFTP server IP address:
Here, set the IP address of the computer on which the TFTP server is active.
– Remote firmware filename:
Here, set the name of the firmware file which is to be transferred to the device.