FL SWITCH 2000
50
PHOENIX CONTACT 107065_en_01
– Release: clicking on the “Release” button releases unused entries.
Pop-up: DHCP Static Leases
This pop-up displays the configured static IP assignment.
Lease list:
– IP address: displays the static IP address assigned.
– Client address: displays the MAC address of the client.
– Delete: clicking on the red cross deletes the entry.
Create new static entry:
– IP address: enter the static IP address that you wish to assign here.
– Client address: enter the MAC address to which you wish to assign a static IP address
here.
– Create: click on the “Create” button to carry out static assignment.
Clear static table: click on the “Clear” button to delete all the static DHCP leases.
5.2.2.11 Local Events
Figure 5-31 “Local Events” web page
Alarm output 1:
Here you can activate the digital alarm output and read the current status (if a red “o” is pres-
ent, this event has occurred).
Events: here you can determine under which conditions a digital alarm output should report
an error.
– Power Supply lost: in the event that US1 or US2 is lost
– Monitored link down: under “Advanced”, select the ports to which link down behavior
should be reported.
– MRP Ring Failure: indicates an error message in the event of an MRP ring error.
To Next Page
Loading...
