FL SWITCH 2000
40
PHOENIX CONTACT 107065_en_01
Network Mask: set the desired subnet mask here.
Default Gateway: set the desired default gateway here.
Management VLAN: set the VLAN here, in which the management is to be located (default:
“1”).
ACD Mode: you can enable/disable the “Address Conflict Detection” function here.
ACD Status Information: clicking on the link opens the “Device Status” page.
Figure 5-19 ACD status information on the “Device Status” page
5.2.2.4 Service
Figure 5-20 “Service” web page
Web Server: you can enable/disable the web server function and select the mode
(HTTP/HTTPS) here.
SNMP Server: you can enable/disable the SNMP server function and the mode (SNMP v2,
SNMP v3) here.
CLI Service:
– Disable: entry of CLI commands is deactivated
– Telnet: entry of CLI commands via Telnet is activated
– SSH: entry of CLI commands via Secure Shell (SSH) is activated
CLI Network Scripting UI:
– Disable: transmission of CLI commands via the network is deactivated
– Enable: transmission of CLI commands via the network is activated
For additional information on using the CLI, refer to “Configuration and diagnostics via
Command Line Interface (CLI)” on page 57.
To Next Page
Loading...
Need help?
General
