Title Service Manual, LPCR2 Page
Service Product Drawing
3323299
B
Released State Date 11/14/2017
7000545 Revision A
Note:
A multiple Wi-Fi networks can be stored in CR2 by repeating above procedure. The CR2 will be automatically
detect and connect to whichever Wi-Fi network is in the range.
Confirm Connection to LIFELINK or LIFENET
Overview: After the Wi-Fi settings have been stored in the CR2, perform this procedure at the intended CR2 location
to make the CR2 check in to LIFELINK or LIFENET. If the intended location only has cellular signal and the CR2 has
cellular capability, this procedure will perform the CR2 Check-In to LIFELINK or LIFENET via cellular network. Device
data from the CR2 will be transferred to LIFELINK or LIFENET during this procedure.
Prerequisites:
• The CR2 must be in its intended location, with access to the Wi-Fi or cellular network.
• Wi-Fi settings must have been stored in the CR2, or
• CR2 must have cellular capability.
Required Time:
• Less than 5 minutes if Wi-Fi signal strength is optimal, or cellular network signal is available at the location.
Steps:
1. Take the CR2 to its intended location.
To Next Page
Loading...
