Title Service Manual, LPCR2 Page
Service Product Drawing
3323299
B
Released State Date 11/14/2017
7000545 Revision A
4. If the CR2 loses connectivity and misses the monthly Auto-Check-In to LIFELINK or LIFENET System, the
Device Readiness status will be set to Outdated. To fix the Outdated status, refer to
Confirm Connection to
LIFELINK or LIFENET to perform manual check-in.
NOTE: Connection from the CR2 to the LIFELINK or LIFENET server is initiated from the CR2 (outbound connection).
The LIFELINK or LIFENET server does not initiate connection with the CR2 (inbound connection).
Change or Remove Wi-Fi Settings on the CR2
Overview: Sometimes a customer’s Wi-Fi network will change. This procedure shows how to change or remove Wi-Fi
settings on the CR2.
Prerequisites:
• Have a LIFELINK or LIFENET login account.
• New Wi-Fi hotspot available at the CR2 intended location
Required Tools:
• USB cable type 2.0 A Male to Micro-B (Cat # 11512-000003)
• Windows computer
• Internet access available from computer
• Wi-Fi network ID and password
Required Time:
• ~10 minutes is required for changing Wi-Fi settings on a CR2.
Steps:
1. Launch Wi-Fi Configuration Tool. (Click Start -> type “Wi-Fi” in the search bar -> select Wi-Fi Configuration
Tool.)
2. Connect USB cable from the CR2 to your computer.
3. Open the lid on the CR2, and wait for the computer to establish a connection with the CR2.
4. When the Connect to Wi-Fi Network screen appears, select a new available network or Add Custom
Network. Then follow the on-screen instructions to finish the Wi-Fi Network setup.
To Next Page
Loading...
