IMPORTANT
THIS PION EER APPARATUS CON TA IN S
LASER OF CLASS 1.
SERVICING OPERATION OF THE APPARATUS
SHOULD BE DON E BY A SPECIALLY
INSTRUCTED PERSON.
Additional Laser Caution
For TLFXJ
For WYXJ5 and KUCXJ
For WAXJ5
For TLFXJ
(VRW2257)
(DRW1975)
(VRW2159)
For WAXJ5
(DRW2372)
LASER DIODE CHARACTERISTICS
FOR DVD : MAXIMUM OUTPUT POWER : 5 mW
WAVELENGTH : 650 nm
FOR CD : MAXIMUM OUTPUT POWER : 7 mW
WAVELENGTH : 780 nm
∗ : See page 160, 161, 164, 165.
1. Laser Interlock Mechanism
The position of the switch (S4400,S4500) for detecting loading
completion is detected by the system microprocessor, and the
design prevents laser diode oscillation when the switch is not
in LPS1 terminal side (when the mechanism is not clamped
and LPS1 signal is high level.)
Thus, the interlock will no longer function if the switch is
deliberately set to LPS1 terminal side. (if LPS1 signal is low
level ).
In the SERVICE MODE∗ the interlock mechanism will not
function.
Laser diode oscillation will continue, if pin 3 (pin 5) of
AN22022A (IC102, IC902) on the SRV1,SRV2 Assy is
connected to GND, or else the terminals of Q102
(Q103), Q902(Q903) are shorted to each other (fault
condition).
2. When the cover is opened, close viewing of the objective lens
with the naked eye will cause exposure to a Class 1 laser
beam.
WARNING !
THE AEL (ACCESSIBLE EMISSION LEVEL) OF THE LASER POWER OUTPUT IS LESS THAN CLASS 1
BUT THE LASER COMPONENT IS CAPABLE OF EMITTING RADIATION EXCEEDING THE LIMIT FOR
CLASS 1.
A SPECIALLY INSTRUCTED PERSON SHOULD DO SERVICING OPERATION OF THE APPARATUS.
For WYXJ5 and KUCXJ
Rear Panel
LABEL CHECK
Printed on the Rear Panel
Printed on the Rear Panel
Printed on the Rear panel
For KUCXJ type Only
EJECT
POWER
S
TO
P
S
T
O
P
REAR
DIS
C
1
U
S
B
1
U
S
B
2
DIS
C
2
EJEC
T
MEP-7000
MU
L
TI ENTE
R
TAINMENT PL
AY
E
R
This product contains mercury. Disposal of this material may be regulated due to environmental
considerations. For disposal or recycling information, please contact your local authorities or the
Electronics Industries Alliance: www.eiae.org.
The backlighting lamp of LCD in this equipment contains mercury. Disposal of this material may
be regulated due to environmental considerations according to Local, State or Federal Laws.
For disposal or recycling information, please contact your local authorities or the Electronics
Industries Alliance: www.eiae.org
To Next Page
Loading...
