PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 4
Nov 30/06
3J20
39-10-00
3. Switches
All switches are rocker-type and are located centrally in the instrument panel.
CAUTION: ALTHOUGH SMALL SWITCH ASSEMBLIES ARE EASIER TO REMOVE IF WIRING IS
FIRST DISCONNECTED, THE LIMITED WORK SPACE BEHIND THE PANEL CAN
RESULT IN BURNED WIRE INSULATION. DO NOT ATTEMPT TO UNSOLDER THESE
SMALL ELECTRICAL CONNECTIONS BEHIND THE INSTRUMENT PANEL UNDER ANY
CONDITIONS. IF NECESSARY, CUT WIRES AT POINT OF CONNECTION. IN ANY
CASE, IT’S BETTER TO DAMAGE THE SWITCH AND REPLACE IT, RATHER THAN
DAMAGE THE WIRING HARNESS LEADS.
A. Removal
(1) Disconnect positive battery cable.
(2) Gain access to the switch from behind the instrument panel.
(3) Squeeze retainer blades on top and bottom of the switch together and push switch from the
panel.
(4) Make note of the placement of, and/or tag, wires on the switch to facilitate installation.
(5) Disconnect wires from the switch. Remove switch.
B. Installation
(1) Connect wires to the switch.
(2) Squeeze retainer blades on top and bottom of the switch together and push switch into panel
until retainer blades engage the panel.
(3) Reconnect positive battery cable.
To Next Page
Loading...
Need help?
General
