1. Select Settings under Mailing on the Home screen.
2. Select System from the list on the left side of the screen.
3. Select Postal Information Upload.
4. Select the Enable Postal Upload Warning check box.
l
A check mark indicates that the warning is enabled.
l
If the check box is empty the warning is disabled.
5. Select and drag the control button along the slide bar to adjust the threshold. Use the + and -
buttons for a more precise selection.
6. Select OK to save your changes.
Setting the system clock
1. Select Settings under Mailing on the Home screen.
2. Select Clock. Select System from the list on the left side of the screen.
3. Select Synchronize clock to synchronize the clock.
4. To turn daylight saving time on or off select On or Off.
Note:
Turn Daylight Saving Time on in the Spring and off in the Autumn.
5. Select the appropriate time zone from the Time Zone list.
6. Select the Home button to return to the Home screen.
Setting system timeouts
System timeouts can be set for your mailing system. You can set any of the system timeouts from five
minutes to four hours, in one minute increments.
1. Select the Settings button in the Mailing tile on the Home screen.
2. Select System from the list on the left side of the screen.
3. Select Timeouts.
4. Select the appropriate timeout from the list and then select the Open timeout button.
5. Select and drag the control button along the slide bar to adjust the timeout. Use the + and -
buttons for a more precise selection.
System Setup
Pitney Bowes User Guide April 2022 183
To Next Page
Loading...
