Refilling the envelope and tape sealant bottle
Pitney Bowes recommends using E-ZSeal® because it helps keep your moistener tank clean and
improves sealing performance. Refill the sealant bottle when your E-ZSeal® is running low.
Your mailing system displays a message telling you when your E-ZSeal® is running low. When you
receive this message, your system can still seal approximately 50 envelopes.
1. Lift the sealant bottle out of the cradle. The bottle is located to the right of the printer module,
behind the stacker.
2. Remove the cap from the bottle.
3. Add enough E-ZSeal® to bring the level up to the bottom of the throat of the bottle. Do not
overfill the envelope sealant bottle.
4. Replace and tighten the cap and return the bottle to its original position.
No power
Issue
The screen is black and the power lights are not lit.
Cause
The device is not receiving any power.
Resolution
Solution 1: Check the power cord
Check that the power cord is securely plugged into the back or the back, left side of your device and a
working electrical outlet.
Maintenance
Pitney Bowes User Guide April 2022 201
To Next Page
Loading...
