Hardware settings
The Hardware settings allow you to view general information about your system, perform routine
maintenance procedures and to adjust hardware settings.
l
General: Select this option to view the model and serial number.
l
Printer: Select this option to replace the ink cartridges, replace the print head, or print a test
pattern.
l
Tape: Select this option to rewind tape for removal and to bring tape to the ready position once a
new roll has been inserted.
l
Sealer: Select this option to view the location of the envelope sealant bottle and the moistener
pad and to adjust the moistness of the sealer.
l
Attached scale: Select this option to zero the scale or to change the vibration setting.
l
Feeder: Select this option to adjust the waiting for envelope timeout.
l
WEIGH-ON-THE-WAY® (W-O-W®): Select this option to select the weighing mode or to set the
weight limit.
l
External printers: Select this option to create a default external printer or to re-establish
connection to an external printer.
Viewing your model and serial number
The model and serial number are helpful to have on hand for rate changes, phone support, and
service.
1. Select Settings under Mailing on the Home screen.
2. Select Hardware from the list on the left side of the screen.
3. Select General. Your system name, model number, PSDPCN, PSDserial number, printer PCN
and printer serial number display on the screen.
4. Select the Home button to return to the Home screen.
Setting the waiting for envelope timeout
Use this option to specify how much time to allow before the feeder stops after the last envelope is
processed. You can set system to run until Stop is selected on the Run Mail screen, or you can set the
system to stop running after a set amount of time, from 5 to 30 seconds.
System Setup
Pitney Bowes User Guide April 2022 194
To Next Page
