4. The device uses tape to print reports and postage for packages or pieces of mail that are
outside the limits specified for mailing materials. SendPro® P1500, SendPro P1000 and
SendPro P2000 systems use adhesive tape only. SendPro P3000 systems can use either
adhesive or gummed tape. The tape is located under the supplies cover, on the right.
5. The ink cartridges contain the ink used to print postage, as well as any additional items (graphic
ad, text message, return address, etc.) you want to appear on your mailpiece.
6. The tape sealant bottle is an optional feature for SendPro P3000 devices. It contains the E-
ZSeal® used for moistening gummed tape. The tape sealant bottle is located to the right of the
printer module, behind the stacker.
7. The wet/dry tape lever is an optional feature for SendPro P3000 devices. Use this lever to set
the type of tape you are using on your system. The wet/dry tape lever is located to the right of
the printer module, behind the stacker.
Push the lever to the right for dry tapes or pressure-sensitive tapes.
Push the lever to the left for wetting gummed tapes.
8. The stacker is where mail is deposited after the postage is applied to the piece of mail. It is
located on the right side of the system. The drop stacker shown here is available with every
device. An optional power stacker is also available.
9. The print heads produce the printed postage.
10. Ink is deposited in the waste ink tray during the print head cleaning process. The device will alert
you when the waste tray is nearing full capacity.
11. The moistener pad assembly moistens the flaps on the envelope. The moistener pad assembly
is located beneath the moistener deck on SendPro® P3000 devices. To access it, lift the top
release lever and then use the blue notch to pull on and open the moistener deck.
Getting started
Pitney Bowes User Guide April 2022 19
To Next Page
Loading...
