Planet WDAP-C1750 - Page 45

User Manual of WDAP-C1750
-35-
VLAN ID
Specify a VLAN ID for each SSID.
Auto Channel
Enable/disable auto channel selection.
A
uto channel selection will automatically set the wireless channel for
the access point’s 2.4GHz frequency based on availability and
potential interference.
When disabled, select a channel manually as shown in the next table.
Auto Channel
Range
Select a range from which the auto channel setting (above) will
choose a channel.
Auto Channel
Interval
Specify a frequency for how often the auto channel setting will
check/reassign the wireless channel.
Check/uncheck the “Change channel even if clients are connected”
box according to your preference.
Channel Bandwidth
Set the channel bandwidth:
 20MHz (lower performance but less interference)
 40MHz (higher performance but potentially higher interference)
 Auto (automatically select based on interference level).
BSS Basic Rate Set
Set a Basic Service Set (BSS) rate: this is the transmission rate for
controlling communication frames for wireless clients.
When auto channel is disabled, select a wireless channel manually:
Object Description
Channel Interval
Select a wireless channel from 1 – 11.
Channel Bandwidth
Set the channel bandwidth:
 20MHz (lower performance but less interference),
 40MHz (higher performance but potentially higher interference)
 Auto (automatically select based on interference level).
BSS Basic Rate Set
Set a Basic Service Set (BSS) rate: this is the transmission rate for
controlling communication frames for wireless clients.