User Manual of WDAP-C1750
-83-
6.4.1.3. Radio Settings
Figure 6-12 NMS Settings—Access Point Radio Settings
Object Description
Wireless
Enable or disable the access point’s 2.4GHz or 5GHz wireless
radio. When disabled, no SSIDs on that frequency will be active.
Band
Select the wireless standard used for the access point.
Combinations of 802.11b, 802.11g, 802.11n & 802.11ac can be
selected.
Auto Channel
Enable/disable auto channel selection. Auto channel selection will
automatically set the wireless channel for the access point’s
2.4GHz or 5GHz frequency based on availability and potential
interference. When disabled, select a channel manually.
Auto Channel Range
Select a range from which the auto channel setting (above) will
choose a channel.
Auto Channel Interval
Specify a frequency for how often the auto channel setting will
check/reassign the wireless channel. Check/uncheck the “Change
channel even if clients are connected” box according to your
preference.
Channel Bandwidth
Set the channel bandwidth or use Auto (automatically select
based on interference level).
BSS Basic Rate Set
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
6.4.1.4. Advanced Settings
The advanced settings are for experienced users only. Please do not change any of the values on this page
unless you are already familiar with these functions.
To Next Page
Loading...
Need help?
General
