4.58
500 EFI FUEL SYSTEM
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.
Digital Wrench™ Communication Errors
If you experience problems connecting to a vehicle or any
Digital Wrench™ related problem, visit the Digital
Wrench™ Knowledge Base for the most current
troubleshooting information, FAQs, downloads and
software updates at: http://polaris.diagsys.com/.
Digital Wrench™ - Diagnostic Connector
The diagnostic connector is located under the front
storage box access cover.
Follow these steps to connect the diagnostic interface
cable to the vehicle to allow Digital Wrench™ use:
1. Assemble the SmartLink Module and attach the PC
Interface Cable to your laptop (see page 3.3).
2. Remove the protective cap from the Digital Wrench™
connector.
3. Connect the Vehicle Interface Cable to the Digital
Wrench™ diagnostic connector.
4. Turn the ignition key to the ‘ON’ position, select the
appropriate vehicle and wait for the status to display
‘Connected’ in the lower left corner of the screen.
5. Once connected, proceed with using Digital
Wrench™.
Picture For Reference Only
To Next Page
Loading...
Need help?
General
