Legend Pro™ System User Manual Version 7
Proprietary Information of Pollogen a company of Lumenis 54
Treatment endpoint is increasing the skin temperature to above 40
o
C (104
0
F ) and below 43
o
C
(109.4
0
F ) and maintaining it for a minimum of 10 minutes. Elevated skin temperature should
be maintained for at least the recommended exposure time.
After 1 minute of treatment, if skin temperature does not increase by at least 4
o
C (39.2
0
F ),
power should be increased by 2 units.
After 1 more minute, if skin temperature does not increase by additional 4
o
C (39.2
0
F ), power
should be increased again by 2 units.
After 1 more minute, if temperature didn’t reach 40
o
C (104
o
F ), continue increasing power,
according to the needed temp adjustment.
Endpoint temperature of 40-42
o
C (104-107.6
o
F) is typically achieved after about 5 minutes
of treatment, occasionally slightly more or less time is required, depending on individual skin
response.
During the treatment, mild skin erythema (redness) and /or edema (swelling) may develop.
These signs are indications of the heating process.
While maintaining endpoint temperature, power could be gently adjusted (increased or
decreased) according to skin temperature and tolerance.
After each TriPollar® treatment, the applicator should be cleaned according to section 10.2.
NOTE:
Never stop applicator’s movement on the skin
When starting a treatment, make sure you are moving the applicator on the skin surface while
initiating the RF power by pressing the foot switch
Do not use mineral oils instead of glycerin.
Post Treatment Care
Refer to the following recommendations to determine your own suitable course of action for post treatment
care.
In case of excessive edema or erythema, cool the area well for at least 15 minutes until heat
sensation fades.
Typically, there will be a slight edema or slight erythema which may last for 1-2 days. If side
effect persists beyond the above-indicated period, the patient should seek medical advice.
Treatment Protocol and Conclusion
Normally, treatment should be administrated once a week for at least 4-6 successive weeks.
Additional treatments are recommended every 4-8 weeks, according to individual needs. Treatment should
be concluded when operator and patient are satisfied with the results.
Do not use mineral oils instead of glycerin.
To Next Page
Loading...