Legend Pro™ System User Manual Version 7
Proprietary Information of Pollogen a company of Lumenis 34
11. USER INTERFACE
11.1 Turning System On
Before turning the System on, verify that the System power supply cord connected to the System inlet on
the back panel and to the power outlet. The System must be connected to grounded power outlet (3-pin)
and must be used only with the cable supplied. (Cable 10A, 250V, 1.8m length).
Warnings:
High voltage is present inside the system.
Delivering excessive energy to the treatment area can damage the skin, resulting in burns.
Lock the wheels during operation of the System (see Figure 1).
Check all connections before plugging in the System’s power supply cord.
Verify that fan is functioning when operating the System. In case of fan failure do not operate the
device, call your Lumenis representative for service.
Do not operate the unit in the presence of electromagnetic interference. Electromagnetic interference
may be caused by electro surgery, diathermy, magnetic resonance imaging or other type equipment.
Portable and mobile are RF communication equipment & may affect operation of this device.
To turn the system on, switch the ON/OFF control to the ON position on the back panel.
The button will turn green.
ON / OFF switch on the back panel
0 position pressed – OFF
1 position pressed - ON
Pay attention that the touch screen quality is OK during the first few seconds of the system check (touch
screen will become black and then turn white). At this time, the Applicator LED will flash (first Green then
Orange) as part of the System’s self-check.
In the following cases, please consult your Lumenis Service representative:
- Residual black pixels while the screen turns white
- No applicator indications appear
To Next Page
Loading...