Legend Pro™ System User Manual Version 7
Proprietary Information of Pollogen a company of Lumenis 7
1. INTRODUCTION TO THE SYSTEM
The Legend Pro™ system intended for dermatological procedures requiring ablation and resurfacing of the
skin when using VoluDerm ™ Energy (Applicator VO). It is also intended for use in dermatologic and general
surgical procedures for the non-invasive treatment of mild to moderate facial wrinkles and rhytides when
using TriPollar® RF Energy (Applicators 1-3)
Intended settings for the device: Clinics & Hospitals.
Intended users: Healthcare professionals (Doctors or Nurses)
Legend Pro™ consists of seven main parts: Main Unit, Applicator VO for VoluDerm and TriFractional
treatments, Applicators 1-3 for TriPollar® treatments, Foot Switch and Patient-Controlled Manual Switch.
The operator can adjust all system parameters from the user interface on the Main Unit.
2. SAFETY INSTRUCTIONS
2.1 Precautionary definitions
The precautionary instructions found in this section and throughout this manual indicated by specific
symbols. Understand these symbols and their definitions before operating this equipment.
The definitions of these symbols are as follows:
Text with a “WARNING” indicator explains possible safety infractions that may
cause serious injury and equipment damage.
Text with a “CAUTION” indicator explains possible safety infractions that
could have the potential to cause minor to moderate injury or damage to
equipment.
Table 1: Precautionary Symbols and Definitions
The System is designed for safe and reliable treatment when used in accordance with proper operation and
maintenance procedures. The operator and all other personnel operating or maintaining the System should
be familiar with the safety information provided in this chapter.
2.2 Cautions
Read this chapter to become familiar with all the safety requirements and operating procedures prior to
System operation.
In order to protect the Legend Pro™ System from use by unqualified personnel, turn the system off
while the system is not in use and lock it in a secure room.
Do not disconnect any of the system components or accessories while the system is switched on.
Keep the Applicators clean. See cleaning instructions in section 13 of this user manual.
Do not allow the Applicator to come in contact with hard objects that can damage it.
Always keep the System’s wheel breaks locked to avoid uncontrolled movement. When movement is
necessary, unlock the breaks before doing so. Always move the System slowly and carefully. The System
may cause injury if proper care is not taken when moving it.
To Next Page
Loading...