POLLOGEN Legend Pro User Manual (English)

To Next Page

Part Number 11600510U ver.7

Legend Pro™

USER MANUAL

Pollogen a company of Lumenis

Proprietary Information

Version 7 September 2019

Table of Contents3
Introduction to the System7
Safety Instructions7
Precautionary Definitions7
Cautions7
Table 1: Precautionary Symbols and Definitions7
Warnings8
VO and Disposable Related Warnings9
Electrical and Mechanical Safety Warnings9
Fire Hazards10
Safety Features10
Indications11
Contraindications11
Precautions11
Possible Side Effects12
System Description12
System Components and Controls12
Main Unit (System Console)13
Figure 1: Legend Pro™ Main System Components (Left - Front View, Right - Back View)13
Control Panel14
Figure 2: User Interface - Control Panel14
Back Panel15
Applicator VO - Intended for the Voluderm ™ and Trifractional™ Treatments15
Figure 3:Back Panel15
Figure 4: VO Applicator15
Figure 5:Gen36 Tip16
Figure 6:Gen12 Tip16
Figure 7: Gen36L Tip16
Figure 8: Gen100 Tip16
Figure 9: H7X7 Tip16
Applicator No. 117
Applicator No. 217
Applicator 1 and 2 Indicator LED Screen17
Applicator No. 317
Figure 10: Applicator No.117
Figure 11: Applicator No.217
Foot Switch18
Patient Controlled Manual Switch18
Figure 12: Applicator No. 318
Figure 14 : Patient Controlled Manual Switch18
Non-Contact Infrared Thermometer19
Technical Specifications19
Figure 15: Non-Contact Infrared Thermometer19
Table 2: Technical Specifications19
Symbols & Labels20
Symbols Used in this User Manual20
Labels Affixed to the System and Its Accessories21
Table 3: Symbols Used Throughout this User Manual21
Table 4: Labels Affixed to the System and Disposables27
Initial Set up28
Unpacking the System28
Figure 16: Unpacking the System28
General Overview and Installation Requirements29
Preparation for Operation29
Applicator and Cable Holder's Assembly Procedure29
Foot Switch Connection31
Patient-Controlled Manual Switch Connection31
Connect VO Applicator31
Attach VO Disposable Tips32
Connect and Lock Applicator No. 132
Connect and Lock Applicator No. 233
Connect and Lock Applicator No. 333
Power Supply Cord Connection33
User Interface34
Turning System on34
Selecting Treatment Application37
Tripollar® Treatment Application37
Select Tripollar® Treatment Applicator37
Select Tripollar® Treatment Course38
Voluderm ™ Treatment Application39
Select VO Treatment Applicator39
Voluderm ™ Treatment Level39
VO Applicator Tips40
Adjusting System's Default (Preset) Parameters41
Operation41
Indications42
Applicator Indication42
Indication on Touch Screen43
Settings43
Home Screen43
Date/Time Selection44
Technician Mode44
Program Upload44
Data Log45
Turning the System off45
Legend Pro™ Treatment46
Voluderm ™ Treatment Using VO Applicator46
Pre-Treatment Preparation46
Treatment Guidelines46
Treatment Parameters47
Treatment Procedure48
Post Treatment Care50
Tripollar® Energy Treatments Using Applicators 1, 2, 351
Pretreatment Guidelines51
During the Treatment51
Treatment Parameters52
Tripollar® Treatment Procedure52
Pre-Treatment Preparation52
Table 5: Treatment Parameters for Tripollar52
Table 6: Typical Treatment Parameters for Face Treatment52
Performing Treatment Procedure53
Post Treatment Care54
Treatment Protocol and Conclusion54
Maintenance55
Cleaning the System55
Cleaning the Applicators55
Fuse Replacement55
Troubleshooting56
Warranty Terms58
Diagram for the Rf Output that Show the Subject Device Power Output Vs. Output60
Control60
Diagram for Power Output at Full and Half for the Load Range of 25 - 1,000Ω60

Need help?

Do you have a question about the POLLOGEN Legend Pro and is the answer not in the manual?

POLLOGEN Legend Pro Specifications

General

RF Frequency	1 MHz
RF Power	Up to 50W
Electrical Requirements	100-240V AC, 50/60Hz
Technology	TriPollar RF, DMA
Display	Touch screen
Treatment Modes	RF, DMA, Trifractional
Power Supply	AC power

POLLOGEN Legend Pro User Manual

Table of Contents

POLLOGEN Legend Pro Specifications