Polycom Vortex EF2210 - LAGC - Enable or Disable Line Input Automatic Gain Control

volatile memory, there will be a delay before an acknowledgment is returned.
Example Description Status Message
Q01LABELOB,Zone 2 Speaker
Set label of output B
to "Zone 2 Speaker".
Q01LABELOB,Zone 2 Speaker
Q01LABELOB,?
Query label for
output B .
Q01LABELOB,<string> , where
<string> is the current label assigned to
output B .
8.55. LAGC -- Enable or Disable Line Input Automatic Gain
Control
This command sets or queries the status of the Automatic Gain Control (AGC) algorithm on input
channels A-B.
This command was introduced in firmware version 2.5.0.
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01LAGCB1
Enable AGC on input channel B.
Q01LAGCB1
Q01LAGCA0
Disable AGC on input channel A.
Q01LAGCA0
Q01LAGCB2
Toggle AGC state on input channel B.
Q01LAGCBx, where x is 0 or 1 depending on
the current state of the AGC on input channel
B.
Q01LAGCA?
Query AGC state on input channel A.
Q01LAGCAx, where x is 0 or 1 depending on
the current state of the AGC on input channel
A.
Q01LAGC*1
Enable AGC on input channels A-B.
Q01LAGC*11
Q01LAGC*0
Disable AGC on input channels A-B.
Q01LAGC*0000
Q01LAGC*2
Toggle AGC state on input channels A-
B.
Q01LAGC*ab, where a and b are each 0 or 1
depending on the current state of the AGC for
each of the line input channels.
Q01LAGC*?
Query AGC state on input channels A-
B.
Q01LAGC*ab, where a and b are each 0 or 1
depending on the current state of the AGC for
each of the line input channels.