● 1 = No Suppression
● 2 = Light Suppression
● 3 = Heavy Suppression
● 4 = Half Duplex
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information
on this type of command. The minimum and maximum values for this command are 1 and 4,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01AECMODE13
Set AEC on input channel 1 to
Heavy Suppression.
Q01AECMODE13
Q01AECMODE1?
Query AEC suppression level on
input channel 1.
Q01AECMODE1x, where x is 1, 2, 3, or 4
depending on the current setting of the AEC
suppression level on input channel 1.
8.4. AGC -- Enable or Disable Mic/Line Input Automatic
Gain Control
This command sets or queries the status of the Automatic Gain Control (AGC) algorithm on input
channel 1 .
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01AGC11
Enable AGC on input channel 1 .
Q01AGC11
Q01AGC10
Disable AGC on input channel 1 .
Q01AGC10
Q01AGC12
Toggle AGC state on input channel 1 .
Q01AGC1x , where x is 0 or 1 depending on the
current state of the AGC on input channel 1 .
Q01AGC1?
Query AGC state on input channel 1 .
Q01AGC1x , where x is 0 or 1 depending on the
current state of the AGC on input channel 1 .
8.5. AGCMAX -- Set Maximum Allowed Mic/Line Input AGC
To Next Page
Loading...
