Polycom Vortex EF2210 - MIC - Enable Microphone Gain Stage on Input

Q01MGAINB,*,>12
Increase the gain for
all crosspoints of input
channel B by 12 dB.
Q01MGAINB,*,abcdefgh , where the value of
each of letters (a, b, etc.) depends on the
current state of each of the crosspoint gains. If
this command was issued after the example
above, then the status message would be
Q01MGAINB,*,èèèèèèèè
Q01MGAINB,*,?
Query the gains for all
crosspoints of input
channel B .
Q01MGAINB,*,abcdefgh , where the value of
each of letters (a, b, etc.) depends on the
current state of each of the crosspoint gains. If
this command was issued after the example
above, then the status message would be
Q01MGAINB,*,èèèèèèèè
8.69. MGATE -- Select Gated or Ungated Microphone Signal
in Matrix
For each crosspoint of the microphone input channels of the main matrix, the microphone signals can
be taken before the automixer (ungated) or after the automixer (gated). This command selects the
gated or ungated microphone signal. If MGATE is set to 1 for a given crosspoint, then the signal will
be gated (taken after the automixer). If MGATE is set to 0 for a given crosspoint, then the signal will
be ungated (taken before the automixer).
This command is a matrix boolean command. See
Section 6.4 and Section 6.1 for more information
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01MGATE1,A,1
Select the gated version of
microphone input 1 to be sent to
output A.
Q01MGATE1,A,1
Q01MGATE1,A,0
Select the ungated version of
microphone input 1 to be sent to
output A.
Q01MGATE1,A,0
Q01MGATE1,A,2
Toggle the gated status of the
crosspoint that routes
microphone input 1 to output A.
Q01MGATE1,A,x, where x is 0 or 1
depending on the current gated status of the
crosspoint.
Q01MGATE1,A,?
Query the gated status of the
crosspoint that routes
microphone input 1 to output A.
Q01MGATE1,A,x, where x is 0 or 1
depending on the current gated status of the
crosspoint.
8.70. MIC -- Enable Microphone Gain Stage on Input 1