Polycom Vortex EF2210 - GMUTEO - Mute All Outputs; ID - Set Device ID

command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01GATEEN0
Disable automatic gating messages.
Q01GATEEN0
Q01GATEEN1
Enable automatic gating messages.
Q01GATEEN1
Q01GATEEN2
Toggle enabled state of automatic
gating messages.
Q01GATEENx, where x is either 0 or 1
depending on whether automatic gating
messages are currently disabled or enabled.
Q01GATEEN?
Query enabled state of automatic gating
messages.
Q01GATEENx, where x is either 0 or 1
depending on whether automatic gating
messages are currently disabled or enabled.
8.52. GMUTEO -- Mute All Outputs
The name of this command is an abbreviation of "Global Mute Outputs." Enabling this option causes
all of the physical outputs to be muted (outputs 1, A, B) . This muting is independent of the normal
output mute command,
MUTEO. This command is provided so that the control program can implement
a "saftey mute" feature. The idea is that if the user accidentally misconfigures the Vortex and
feedback begins to occur, they can press the saftey mute to instantly mute all outputs before they
damage their equipment or ears.
This command is a boolean command. See
Section 6.1 for more information on this type of
command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01GMUTEO1
Enable global output mute.
Q01GMUTEO1
Q01GMUTEO0
Disable global output mute.
Q01GMUTEO0
Q01GMUTEO2
Toggle global output mute.
Q01GMUTEOx , where x is 0 or 1 depending on the
current state of the global output mute.
Q01GMUTEO?
Query acknowledgement mode.
Q01GMUTEOx , where x is 0 or 1 depending on the
current state of the global output mute.
8.53. ID -- Set Device ID
This command sets or queries the Device ID for the Vortex. Typically, the device ID is set from the