Polycom Vortex EF2210 - PRESETP - Set Which Preset will be Activated at Power-Up; PRESETQ - Execute a Preset Quietly; PRESETW - Save a Preset

Q01PRESETL18
will be displayed.
8.100. PRESETP -- Set Which Preset Will Be Activated At
Power-Up
This command sets or queries the power-up preset, which is executed each time the device powers
up. The power-up preset must be one of the factory presets (0-15) or one of the user presets (16-
47).
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved
each time it is changed. It will retain its value after power-down. Since this command writes to non-
volatile memory, there will be a delay before an acknowledgment is returned.
Example Description Status Message
Q01PRESETP16
Set the power-up preset to be user
preset 16.
Q01PRESETP16
Q01PRESETP?
Query the current power-up preset.
Q01PRESETPx , where x is between 0 and
47 depending on which preset is currently
set to be the power-on preset.
8.101. PRESETQ -- Execute a Preset Quietly
This command executes the preset corresponding to the specified number, which must be between 0
and 47. The preset must either be a pre-defined factory preset (0 - 15) or a user preset (16 - 47) that
has been previously defined via the
PRESETW command. If the specified preset is empty, then an
error condition of ERROR#070 will be returned. If one or more of the commands in the preset
generated errors, then an error condition of ERROR#072 will be returned.
When the PRESETQ command executes, status messages for all of the commands in the preset will
not be generated. The PRESETQ command is provided so that a control system can execute a preset
and not generated heavy data traffic from the resulting status messages. Of course, this assumes that
the control system is not interested in any of the acknowledgements. The
PRESETX command can be
used to execute the preset without suppressing the status messages.
Example Description Status Message
Q01PRESETQ18
Execute preset number 18 without generating any status
messages.
Q01PRESETQ18
8.102. PRESETW -- Save a Preset
This command writes the current settings of the device into the user preset with the specified