8.37. DELAYO -- Set Output Delay
This command sets the amount of output delay (in tenths of milliseconds) on each of the three output
channels (1, A, B) . Use of the wildcard character (*) for specifying the channel is not supported for
this command. The output delay can be separately enabled or disabled via the
DELAYOE command.
This command is an integer command. See
Section 6.2 for more information on this type of
command. The minimum and maximum values for this command are 0 and 3400, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01DELAYOB1500
Set output delay on output
channel B to 150 ms (1500
tenths of milliseconds).
Q01DELAYOB1500
Q01DELAYOB>1700
Increase output delay on output
channel B by 170 ms (1700
tenths of milliseconds.)
Q01DELAYOBx , where x is between 0 and
3400 depending on the current output delay
setting for output channel B . If this
command is issued after the above example,
then the status message will be
Q01DELAYOB3200 .
Q01DELAYOB?
Query current output delay on
output channel B .
Q01DELAYOBx , where x is between 0 and
3400 depending on the current output delay
setting for output channel 2. If this command
is issued after the above example, then the
status message will be Q01DELAYOB3200 .
8.38. DELAYOE -- Enable Output Delay
This command sets or queries the enabled state of the output delay for each of the three output
channels (1, A, B) .
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01DELAYOEB1
Enable output delay on output B
.
Q01DELAYOEB1
To Next Page
Loading...
