Q01PEQIGB,1,?
Query current gain setting of
parametric EQ on input B , band
1.
Q01PEQIGB,1,g , where g is the current
setting of the gain parameter for the
parametric EQ on input B , band 1. If the
gain parameter of this filter is set to the
same value given in the example above,
then the status message will be
Q01PEQIGB,1,-20 .
8.87. PEQIS -- Set Slope Parameter for Specified
Parametric EQ Input Stage
This command sets or queries the slope parameter (in dB per octave) for the parametric equalizer
(EQ) filters on input channels 1, A, and B . Each channel has five bands of parametric EQ that can be
independently controlled.
For the Linkwitz-Riley filters, the slope can either be 12 or 24 (dB/Octave).For the low shelf and high
shelf filters, the minimum value for the slope parameter is 1, and the maximum value is 1.2 times the
current value of the gain parameter. See the
PEQIG command for information on the gain parameter.
This command has the same format and restrictions as the
PEQIA command except that only one
parameter, the slope, is specified instead of all the parameters. See the
PEQIA command for more
information. To set the slope parameter for an output parametric EQ filter, use the
PEQOS command.
To set all the parameters for an output parametric EQ filter, use the
PEQOA command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01PEQIS1,2,1
Set the slope of the parametric
EQ on input 1 , band 2 to 1 dB
per octave.
Q01PEQIS1,2,1
Q01PEQISB,1,?
Query current slope setting of
parametric EQ on input B , band
1.
Q01PEQISB,1,s , where s is the current
setting of the slope parameter for the
parametric EQ on input B , band 1. If the
slope parameter of this filter is set to the
same value given in the example above, then
the status message will be Q01PEQISB,1,1 .
8.88. PEQIT -- Set Type Parameter for Specified
Parametric EQ Input Stage
The type parameter specifies what type of filter is executed for the specified band of the specified
input channel. The different filter types and their corresponding values are shown in the table below.
To Next Page
Loading...
