This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01PEQIF1,2,1250
Set frequency of parametric
EQ on input 1 , band 2 to
1250 Hz.
Q01PEQIF1,2,1250
Q01PEQIFB,1,?
Query current frequency
setting of parametric EQ on
input B , band 1.
Q01PEQIFB,1,f , where f is the current
setting of the frequency parameter for the
parametric EQ on input B , band 1. If the
frequency parameter of this filter is set to the
same value given in the example above, then
the status message will be
Q01PEQIFB,1,1250 .
8.86. PEQIG -- Set Gain Parameter for Specified Parametric
EQ Input Stage
This command sets or queries the gain parameter (in dB) for the parametric equalizer (EQ) filters on
input channels 1, A, and B . Each channel has five bands of parametric EQ that can be independently
controlled.
The minimum and maximum values for the gain parameter are -20 and 20, respectively.
This command has the same format and restrictions as the
PEQIA command except that only one
parameter, the gain, is specified instead of all the parameters. See the
PEQIA command for more
information. To set the gain parameter for an output parametric EQ filter, use the
PEQOG command.
To set all the parameters for an output parametric EQ filter, use the
PEQOA command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01PEQIG1,2,-20
Set the gain of the parametric
EQ on input 1 , band 2 to -20
dB.
Q01PEQIG1,2,-20
To Next Page
Loading...
Need help?
General
