Polycom Vortex EF2210 User Manual

Query phone output gain.
, where x is the new value of the
phone output gain. If this command
was issued after the example above,
then the status message would be .
8.106. SGGAIN -- Set Gain of Signal Generator
This command sets the gain of the internal signal generator. The value of SGGAIN specifies the gain
in dB applied to signal generator. A gain of 0 dB produces a signal at nominal level (-20 dB full scale).
This command is an integer command. See
Section 6.2 for more information on this type of
command. The minimum and maximum values for this command are -100 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01SGGAIN6
Set signal generator gain to 6 dB.
Q01SGGAIN6
Q01SGGAIN>3
Increase signal generator gain by 3 dB.
Q01SGGAINx , where x is the new value of
the signal generator gain. If this command
was issued after the example above, then
the status message would be Q01SGGAIN9
.
Q01SGGAIN?
Query signal generator gain.
Q01SGGAINx , where x is the new value of
the signal generator gain. If this command
was issued after the example above, then
the status message would be Q01SGGAIN9
.
8.107. SGMUTE -- Mute Signal Generator
This command controls the muting of the signal generator.
This command is a boolean command. See
Section 6.1 for more information on this type of
command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01SGMUTE1
Mute signal generator.
Q01SGMUTE1
Q01SGMUTE0
Unmute signal generator.
Q01SGMUTE0

Polycom Vortex EF2210 Specifications

General

Brand	Polycom
Model	Vortex EF2210
Category	Telephone Accessories
Language	English