Polycom Vortex EF2210 - VTXMODO - Enable VTX Mode on Specified Inputs

Q01VTXMODI*10
Enable VTX mode on input A and
disable VTX mode on input B.
Q01VTXMODI*10
Q01VTXMODI*2
Toggle status of VTX mode on
inputs A-B.
Q01VTXMODI*ab, where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current status VTX mode on the corresponding
input. If this command was sent after the
example above, then the status message
would be Q01VTXMODI*01.
Q01VTXMODI*?
Query status of VTX mode on
inputs A-B.
Q01VTXMODI*ab, where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current status VTX mode on the corresponding
input. If this command was sent after the
example above, then the status message
would be Q01VTXMODI*01.
8.116. VTXMODO -- Enable VTX Mode on Specified Inputs
Vortex devices can be connected to a Polycom VTX 1000 in order to use the wideband capabilities of
that device. When connecting to a VTX 1000, special proccessing is done on the Vortex in order to
guarantee compatibility with the VTX 1000. This command enables processing for the VTX 1000 on
the specified line output or outputs.
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01VTXMODO11
Enable VTX mode on output 1.
Q01VTXMODO11
Q01VTXMODOA0
Disable VTX mode on output A.
Q01VTXMODOA0
Q01VTXMODO12
Toggle status VTX mode on
output 1.
Q01VTXMODO1x, where x is either 0 or 1
depending on the current status of VTX mode
on output 1.
Q01VTXMODOA?
Query status of VTX mode on
output A.
Q01VTXMODOAx, where x is either 0 or 1
depending on the current status of VTX mode
on output A.
Q01VTXMODO*1
Enable VTX mode on outputs 1,
A-B.
Q01VTXMODO*111
Q01VTXMODO*0
Disable VTX mode on outputs
1, A-B.
Q01VTXMODO*000