Polycom Vortex EF2210 - NC - Enable Noise Cancellation

Q01MUTEOB2
Q01MUTEOBx , where x is either 0 or 1
depending on the current mute status of the
output.
Q01MUTEOB?
Query mute status of output B .
Q01MUTEOBx , where x is either 0 or 1
depending on the current mute status of the
output.
Q01MUTEO*1
Mute all outputs (1, A, B) .
Q01MUTEO*111
Q01MUTEO*0
Unmute all outputs (1, A, B) .
Q01MUTEO*000
Q01MUTEO*100
Mute output 1 and unmute outputs
A and B.
Q01MUTEO*100
Q01MUTEO*2
Toggle mute status of all outputs.
Q01MUTEO*abc where each of the letters (a,
b, etc.) is either 0 or 1 depending of the
current status of the mute on the
corresponding output. If this command was
sent after the example above, then the status
message would be Q01MUTEO*011.
Q01MUTEO*?
Query mute status of all outputs.
Q01MUTEO*abc , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current status of the mute on the
corresponding output. If this command was
sent after the example above, then the status
message would be Q01MUTEO*011
8.77. NC -- Enable Noise Cancellation
This command sets or queries the status of the Noise Cancellation (NC) algorithm on input channel 1 .
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
Q01NC11
Enable NC on input channel 1 .
Q01NC11
Q01NC10
Disable NC on input channel 1 .
Q01NC10
Q01NC12
Toggle NC state on input channel 1 .
Q01NC1x , where x is 0 or 1 depending on
the current state of NC on input channel 1 .
Q01NC1?
Query NC state on input channel 1 .
Q01NC1x , where x is 0 or 1 depending on
the current state of NC on the input channel.
Q01NC*1
Enable NC on input channel 1.
Q01NC*1