8.81. NVPSWD -- Change Non-Volatile Memory Password
This command sets or queries the non-volatile memory password. This password is used in
conjunction with the NVLOCK command. The non-volatile memory must be unlocked ('NVLOCK0') in
order to use this command to set or query the non-volatile memory password. If the non-volatile
memory is locked, then this command will result in 'ERROR#004'. The examples below assume that
the non-volatile memory is unlocked.
Example Description Status Message
Q01NVPSWDlemur
Set non-volatile memory password to 'lemur'.
Q01NVPSWDlemur
Q01NVPSWD?
Query the current non-volatile memory password.
Q01NVPSWDlemur
8.82. PEQIA -- Set All Parameters for Specified Parametric
EQ Input Stage
This command sets or queries all of the parameters for the parametric equalizer (EQ) filters on input
channels 1, A, and B . Each channel has five bands of parametric EQ that can be independently
controlled.
The input parametric EQ filter parameters can be set individually via the
PEQIT, PEQIF, PEQIB,
PEQIG, PEQIS, and PEQIE commands. The output parametric EQ filter parameters can be set
simultaneously via the
PEQOA command or individually with the PEQOT, PEQOF, PEQOB, PEQOG,
PEQOS, and PEQOE commands.
When using this command, you must specify all of the following parameters.
Description Value Range Units
Channel 1, A, B N/A
Band 1-5 N/A
Filter Type 1-5
1 = parametric filter
2 = low shelf
3 = high shelf
4 = lowpass
5 = highpass
6 = Linkwitz-Riley lowpass
7 = Linkwitz-Riley highpass
Frequency 20 - 20000 Hz
Bandwidth 5 - 200 1/100th octave
Gain -20 - 20 dB
Slope
1 - 1.2 * Gain for shelving filters, 12 or 24 for Linkwitz-
Riley filters
dB per octave
To Next Page
Loading...
