Q01VTXMODO*100
Enable VTX mode on output 1
and disable VTX mode on
output A-B.
Q01VTXMODO*100
Q01VTXMODO*2
Toggle status of VTX mode on
outputs 1, A-B.
Q01VTXMODO*abc, where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current status VTX mode on the corresponding
output. If this command was sent after the
example above, then the status message would
be Q01VTXMODO*011.
Q01VTXMODO*?
Query status of VTX mode on
outputs 1, A-B.
Q01VTXMODO*abc, where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current status VTX mode on the corresponding
output. If this command was sent after the
example above, then the status message would
be Q01VTXMODO*011.
To Previous Page
Loading...
